A nice 3-row core Model A radiator. Comes complete with neck and outlet. 6 fins per inch, 95 tubes. U.S.A.A8005A
Heavy Duty Ford Model A radiator. Comes complete with neck and outlet. 8 fins per inch, 95 tubes. U.S.A. A8005BHD
Sold as a pair51 x 32 x 4 mm
This 4 inch pipe has a nut welded in the center to fit the temp. probe. Cut upper hose and insert pipe. Set includes 2 clamps. Powder coated. Old Part # A8256P
Connect the bottom neck of the radiator with the water inlet on the sides of the block. Black Powder Coated. Petcock does not come with the pipe
Used between the bottom neck of the radiator and the water inlet on the side of the block. Use the early style with the powerhouse style generator A-Ford 1928-1929 OEM: A-8291-AR
A-Ford 1928-31A8507
A8130F
American made pump. Don't forget to grease pump before using and EVERY 500 MILES. This is built up as original with a regular pack nut/packing and a stainless steel shaft Replaces: A-8501
This Model A Ford ball bearing water pump has been bored out to accept a ball bearing that is pressed onto the shaft to eliminate end play. It also has a sealed rear bushing assembly with a stock pack nut. The pack nut contains graphite packing as a...
This Model A Ford ball bearing water pump has been bored out to accept a ball bearing that is pressed onto the shaft to eliminate end play. It also has a sealed rear bushing assembly with a stock pack nut. The pack nut contains graphite packing as a...
A complete rebuild kit with stainless steel shaftA-Ford 1928-31
This fan is balanced, powder-coated Black and includes the fan pulleyOne piece aluminum casting for added safety. OEM: A8600A
castle nut, woodruff key, and cotter pin to mount fan
Shaft with original stock lenght. This stainless shaft is made from 17-4PH stainless steel. A very hard and durable material that is magnetic, so don't be alarmed when your magnet sticks to the shaft. A-Ford 1928-31 OEM: A-8510-SS
This shaft is 1/4" longer than the stock shaft to accommodate a worn cylinder head where the shaft rides. This stainless shaft is made from 17-4PH stainless steel. A very hard and durable material that is magnetic, so don't be alarmed whe...
The roller bearing that the shaft rides in the nose of the pump A-Ford 1928-31 OEM: A-8530
This sleeve is pressed into the nose of the water pump casting, and the roller bearing rides in this sleeve A-Ford 1928-31 OEM: A-8535
cup shaped washer that is on both sides of the front roller bearing on the pump. The felt (A-8542) rests in this cup A8540A
A8542
A-8523 specialA-Ford 1928-29
Uses modern seals and O rings to eliminate water pump leaks.A-Ford 1930-31OEM: A8523 LKZ
The leakless style bushing has two neoprene seals to stop any leakage. It mounts on the rear of the pump and the pack nut screws onto thisA & B Ford 1928-34
Split graphite/lead style seal set. Fits ans seals Model A waterpump 1928-31
Lenght: 30 cm graphite impregnated ePTFF composite packing
A-8501
A-8513Priced each
This special brass fitting with a screw on cap was used to grease the rear bushing assembly of the pump A-Ford 1928-31 OEM: A8501-FIT
A-8501-W